Rear spring, approximately 20-25mm lowered, VTR250

[HYPERPRO 22015231 Rear Spring, Lowdown Approx. 20-25mm for VTR250 Suspension]
■Rear Spring
A unique lowdown spring from Hyperpro that lowers the vehicle height by changing the spring rate and adjusting the oil level, without significantly altering the free length of the spring.
Enjoy the smooth ride of the constant rising rate, which flexibly absorbs shocks and firmly supports the bike deep into its travel.
Compatible models
HONDA VTR250 '00-'12 (TYPE-LD not compatible)
Specifications
Lowdown: Approx. 20-25mm
Spring part number: 1346
Preload adjustment: 7-9mm
Sag value: 30mm
Compression adjustment: None
Rebound adjustment: None
*Cannot be installed on rear shocks without a preload adjuster.
*When using the side stand, park on a flat surface with the bike in first gear. (The vehicle will be more upright than with the stock setup due to the lowdown.)
*After installation, the vehicle's balance will change significantly. Always adjust the front and rear settings before riding.
*Lowdown parts are considered specified parts, so no structural modification procedures are required.
*For lowdowns of 30mm or more, a short side stand may be necessary depending on the vehicle's condition. For models with preload adjustment, set the preload while adjusting to a lowdown amount that allows the side stand to be used.
*The image is for illustrative purposes only, and the design and specifications of the products shown may change without notice. Please understand.