Brake Master Cylinder VRC Clamp Reverse Thread Mirror Holder Lever Ratio 18-16mm φ16 Short Lever

【Gale Speed VRC16A-17BGS Brake Master Cylinder VRC Clamp Reverse Thread Mirror Holder Lever Ratio 18-16mm φ16 Short Lever】
■Brake Master φ16
・Forged radial master cylinder equipped with a uniquely developed variable ratio lever. The fulcrum to operating point of the lever can be adjusted up to 2mm in 0.25mm increments, allowing you to fine-tune the brake feel, which was previously dependent on the caliper combination, to a more optimal state.
・In addition, three types of clamp (four types for brakes) and two types of lever sizes are available to suit the vehicle and individual rider preferences. By making all combination patterns standard equipment, the hassle of purchasing options is reduced.
●Only glycol ether-based brake/clutch fluid can be used. Do not use silicone-based or mineral-based brake fluid. (This may cause malfunction or fluid leakage)
■Bolt Pitch: P1.00
[Round Lever]
・Features a round-shaped lever that can be pulled by sliding with a finger.
●Photos may differ from the actual product.
●Only glycol ether-based brake/clutch fluid can be used. Do not use silicone-based or mineral-based brake fluid as it may cause malfunction or fluid leakage.
●Bolt Pitch: P1.00
●This is the price for the master cylinder body only.
●When installing, please ensure proper torque management. The installation torque for the M6 clamp bolt is 12N・m.
●If the measuring point for the vehicle height listed on the vehicle inspection certificate is the master cylinder (mainly the master cup), changes exceeding ±40mm require a structural change procedure.
●The main body and clamp parts are treated with highly durable "hard anodizing." Unlike general colored anodizing, it features a natural color finish. Therefore, the color tone may vary from the posted photos depending on various conditions. Returns or exchanges due to color tone are not accepted. Please understand.
Specifications:
・Cylinder Diameter: φ16
・Fulcrum to Operating Point: 18-16mm (0.25mm increments)
・Clamp Type: Reverse Thread Mirror Holder
・Lever Size: Short (Round Type)
Image Notes:
*The photo shows a standard lever.
*The image is for illustration purposes, and the design and specifications of the product shown are subject to change without notice. Please understand.