Hot Grips Heavy Duty Built-in 4Sn

【DAYTONA 45851 Hot Grips Heavy Duty Built-in 4Sn Grip Heater Motorcycle Parts Handlebar Area】
■Product Description
Through-hole type grip heaters that allow for bar ends to be installed. Equipped with a quick heat function that provides rapid heating for up to 4 minutes when powered on. Integrated 4-stage switch allows temperature levels to be changed by pressing a button.

■Specifications
Universal (for 22.2mm handlebar diameter)
Operating voltage: DC12V
Type: Through-hole type
Size: Total length: approx. 120mm
Grip diameter: Outer diameter - 33.6mm
Inner diameter - Right approx. 25mm / Left approx. 22mm

■Other Notes
*Due to manufacturing tolerances and individual differences, the inner diameter may be larger than stated above.
*For 12V only. Cannot be installed on battery-less vehicles or 6V vehicles.
*For Φ22.2 handlebars. Cannot be installed on Φ25.4 (1 inch) vehicles.
*Cannot be installed on vehicles with insufficient power generation capacity or AC (alternating current) vehicles, such as Class 1 Mopeds/Class 2 Mopeds.
*Cannot be installed on vehicles with a thin grip inner diameter (e.g., Address 110, Address V100 / inner diameter approx. 19mm). Please measure and confirm the handlebar outer diameter and sleeve diameter before installation.
*Cannot be installed on our FLAT throttle sleeves (61628/61970/70360/70673/77240) without modification. Ribs must be cut.
*For EFI (fuel injected) vehicles, do not connect to the vehicle diagnostic connector, even if a 12V power source is available.
*Do not perform installation with wet hands. There is a risk of electric shock, which is extremely dangerous.
*Adhesive is required for installation. Please use our recommended adhesive.

■Notes
*Images are for illustration purposes only. Includes products with different sizes and colors.
*Product design and specifications are subject to change without notice. Thank you for your understanding.