Forged Aluminum Kickstand WR250R WR250X

【ZETA Dirt Freak ZE56-8619 Forged Aluminum Kickstand WR250R WR250X Side Stand for Lowered Vehicles】
・Primarily features a short type that is 25mm shorter than the stock stand for lowered vehicles *1.
・Avoids unstable vehicle conditions caused by changes in ride height, set to a length that allows safe use even on rough roads.
・The detachable tip can be replaced with an optional tip to adjust the height for standard or high-lift vehicles *2.
・Made from forged A2014, ensuring strength and durability.
*1 Some vehicles also have settings for high-lift vehicles and standard vehicles.
*2 The lean angle varies depending on the ride height. If the tip length is not suitable, please refer to the optional tip conversion table below and replace the tip.
Compatible models:
YAMAHA:
・WR250R / '08 - '17
・WR250X / '08 - '17
*When assembling the tip, be sure to apply thread-locking compound to the tip mounting bolt.
*If you are concerned about the tip rotating, apply adhesive for interference fit to the joint between the shaft and the tip.
*Applying adhesive to the joint will make it difficult to replace the tip later, so please take this measure only if necessary.
*The image is for illustration purposes only, and the design and specifications of the products shown are subject to change without notice. Please understand.