Billet Aluminum Generator Cover Silver Anodized 20mm Offset

【G-Craft 37125 Aluminum Billet Generator Cover Silver Anodized 20mm Offset】
The sprocket shaft is supported by the sprocket cover bearing, reducing countershaft wear caused by offset.
This is a set of sprocket cover and generator cover.
A dust seal is provided inside the cover to reduce the ingress of sand and dust into the bearing.
The bolt sections have been knock-pin processed to increase strength.
This is an essential item for achieving the 10-inch 5.5J style.
Surface treatment: Silver anodized finish
Size: 20mm offset
Material: A2017 alloy
Notes
*Required to use G-Craft part number 36028, 20mm offset sprocket.
*Can be installed on Honda horizontal engines (however, not compatible with JAZZ, Magna, and other specially shaped engines).
*When installing on 6V models, one bolt at the bottom right of the cover cannot be secured.
*Depending on the model year, the shift pedal and generator cover may interfere. In such cases, please use a shift pedal for 12V Monkey.
*FI (fuel injection) Monkey models cannot be installed due to the different shape of the generator cover.
*When installing G-Craft rear sets, please offset the pedal outward using the included aluminum collar. (To prevent the shift rod from interfering with the cover)
*Images are for illustration purposes only, and the design and specifications of the products shown are subject to change without notice. Please be aware.