Sprocket Spacer for Dax Hub, Silver Anodized, 20mm

【G-Craft 39040 Sprocket Spacer for DAX Hub, Silver Anodized, 20mm】
This part is necessary to achieve the correct chain line when installing a DAX/Chaly Super Wide Swingarm and G-Craft 10-inch 5.5J wide wheel.
It adopts a hybrid structure of iron and aluminum to ensure component strength.
The rear sprocket to be used is for NSR50/80 or NSF100 (sprockets with fewer than 31 teeth cannot be installed).
For the front, use a 20mm offset sprocket (36028).
Compatible with both 3-spoke and 4-spoke hubs (tubeless type hubs are not compatible).
Surface treatment: Silver anodized finish
Size: 20mm
Material: A2017 material, chromoly steel
Notes
*This product must be used in conjunction with a G-Craft Super Wide Swingarm, genuine Honda hub, front 20mm offset sprocket (36028, 36030), billet generator cover (37125), and G-Craft 5.5J wheel. Using it with products from other manufacturers may lead to damage.
*If the end eye of the rear shock is thicker than the genuine part, the chain may interfere with the suspension mounting bolt.
*This product is designed exclusively for genuine Honda horizontal 50cc engines. Using it with an engine displacement of more than 50cc may lead to damage to engine parts.
*The sprocket load is designed to be received by the hole in the center of the spacer joint. When installing, it may be a light press fit depending on the hub you are using. This is due to paint thickness or individual differences in hubs, so please tap it into place with a plastic hammer.
*If you are doing custom painting, please check the fitting part and mask it accordingly.
*The images are for illustration purposes only, and the design and specifications of the products shown may change without notice. Please be aware of this.