Swingarm NSR (Type D) Linkless Standard No Stabilizer Buff +0cm Ape 50/100

【G-Craft 90150 Swingarm NSR (Type D) Linkless Standard No Stabilizer Buff +0cm APE50/100】
APE50/100 Swingarm NSR (Type D) Linkless STD +0cm No Stabilizer
This swingarm allows the installation of NSR50/80 (Type D) wheels.
The swingarm width is manufactured at 184-187mm.
A U-shaped brake stopper is welded to the inside of the swingarm.
By using caliper support part number 33136 and rear disc hub part number 39149, you can convert from a drum-spec vehicle to a disc-spec vehicle.
Disc conversion is possible using caliper support part number 33136 and NSR50/80 wheels.
Compatible models
APE50/100
Surface treatment: Buffed finish
Size: +0cm
Material: 7N01, A5083 material used
Accessories
(1) Chain adjuster block 1 set (dedicated for each pipe shape)
(2) Collar for frame side shock mount 5.4mm 2 pieces (repair part number 68139/1 piece included)
(3) Axle nut M12 1 piece (repair part number 38001)
(4) Axle shaft 230mm 1 piece (repair part number 38061)
(5) Bolt set for swingarm side shock mount
Bolt 1 piece (repair part number 65235)
Nut 1 piece (repair part number 65229)
Washer 2 pieces (repair part number 65090/1 piece included)
Notes
*STD (Standard), T/S (Triple Square), T/S Mini (Triple Square Mini), S/A (Swing Arm) are abbreviations.
*APE normal drum hub cannot be used.
*The basic stabilizer is on the bottom side in the case of linkless.
*Rear shocks are compatible with NSR50/80 (APE normal cannot be used)
*12-3.75J aluminum wheels can be installed.
*The image is for illustration purposes only, and the design and specifications of the products shown are subject to change without notice. Please understand.