GC-019/GC-020 Frame-Specific Wide Swingarm Monoshock Standard No Stabilizer Buff +12cm Monkey Gorilla

【G-Craft 90614 GC-019/GC-020 Frame-Specific Wide Swingarm Monoshock Standard No Stabilizer Buff +12cm Monkey Gorilla】
GC-019, GC-020 Frame-Specific S/A Wide +12cm STD No Stabilizer
The wide swingarm for GC-019 and GC-020 aluminum frames is manufactured with the same width (187-190mm) as the Monkey wide swingarm.
It can use the stock Monkey hub as well as the 39048 wide rear disc hub.
This swingarm is compatible with both drum and disc brakes.
The triple square pipe swingarm, which uses a strong "H-shaped cross-section," is favored by over 80% of users who choose 16cm or longer.
When mounting an 8-4.0J wheel, a 4mm offset front sprocket and a 4mm rear sprocket spacer are required.
When mounting a 10-4.0J wheel, a front sprocket is not required as it can be offset on the engine side. (If using a normal hub, an 8mm offset sprocket spacer is required)
Compatible models
Monkey, Gorilla (for GC-019, GC-020 aluminum frames)
Surface treatment: Buff finish
Size: +12cm
Material: 7N01, A5083 material used
Included accessories
(1) Chain adjuster block 1 set (specific to each pipe shape)
(2) Shock mounting bolt set
Bolt 1 (Repair part number 65235)
Nut 1 (Repair part number 65229)
Washer 2 (Repair part number 65090/1 piece)
(3) Seat fixing collar 22mm 2 (Repair part number 68133/1 piece)
(4) Drum brake rod 1 (depending on swingarm length)
(5) Axle shaft 230mm 1 (Repair part number 38061)
(6) Axle collar 10mm 2 (Repair part number 68134/1 piece)
(7) Axle nut M12 1 (Repair part number 38001)
Notes
*STD (Standard), T/S (Triple Square), T/S Mini (Triple Square Mini), S/A (Swingarm) are abbreviations.
*Up to 8-inch 4.0J and 10-inch 4.0J can be mounted. (+4cm or more is required)
*Only triple square pipes have a chain slider on the bottom.
*Please use genuine NSR50/80 rear shocks. (Ohlins TTX cannot be mounted)
*The basic stabilizer is on the bottom side.
*Exclusively for GC-019 and GC-020 aluminum frames. Other frames cannot be mounted.
*When using a disc brake, the brake stopper needs to be cut. (Cut 10mm from the tip)
*The image is for illustration purposes, and the design and specifications of the products shown may change without prior notice. Thank you for your understanding.