GC-019/GC-020 Frame-Specific Wide Swingarm Monoshock Standard Non-Stabilized Buff Finish +14cm Monkey Gorilla

【G-Craft 90615 GC-019/GC-020 Frame Only Wide Swingarm Monoshock Standard No Stabilizer Buff +14cm Monkey Gorilla】
GC-019, GC-020 Frame Only S/A Wide +14cm STD No Stabilizer
The wide swingarms for GC-019 and GC-020 aluminum frames are manufactured with the same width as Monkey wide swingarms (width 187-190mm).
You can use the stock Monkey hub as is, or use the 39048 wide rear disc hub.
This swingarm is compatible with both drum and disc brakes.
The triple square pipe swingarm, which uses a strong "eye-shaped cross-section," is supported by over 80% of users who choose 16cm or longer pipes.
When installing 8-4.0J, a 4mm offset sprocket is required for the front and a 4mm sprocket spacer for the rear.
When installing 10-4.0, an offset can be made on the engine side, so a front sprocket is not required. (If using a normal hub, an 8mm offset sprocket spacer is required)
Compatible models
Monkey, Gorilla (for GC-019, GC-020 aluminum frames)
Surface treatment: Buffed finish
Size: +14cm
Material: 7N01, A5083 material used
Accessories
(1) Chain adjuster block 1 set (specific to each pipe shape)
(2) Shock mounting bolt set
Bolt 1 (repair part number 65235)
Nut 1 (repair part number 65229)
Washer 2 (repair part number 65090/1 piece)
(3) Seat fixing collar 22mm 2 (repair part number 68133/1 piece)
(4) Drum brake rod 1 (depending on swingarm length)
(5) Axle shaft 230mm 1 (repair part number 38061)
(6) Axle collar 10mm 2 (repair part number 68134/1 piece)
(7) Axle nut M12 1 (repair part number 38001)
Notes
*STD (Standard), T/S (Triple Square), T/S Mini (Triple Square Mini), S/A (Swingarm) are abbreviations.
*Up to 8-inch 4.0J and 10-inch 4.0J can be installed. (Requires +4cm or more)
*Only triple square pipes have chain sliders on the bottom as well.
*Please use genuine NSR50/80 rear shocks. (Ohlins TTX cannot be installed)
*The basic stabilizer will be on the lower side.
*Exclusive for GC-019 and GC-020 aluminum frames. Other frames cannot be installed.
*When using a disc brake, the brake stopper needs to be cut. (Cut 10mm from the tip)
*Images are for illustration purposes only, and the design and specifications of the products shown are subject to change without notice. Please be aware.