GC-019/GC-020 Frame Only Wide Swingarm Monoshock Standard No Stabilizer Buffed +16cm Monkey Gorilla

【G-Craft 90616 GC-019/GC-020 Frame Only Wide Swingarm Monoshock Standard No Stabilizer Buffed +16cm Monkey Gorilla】
S/A for GC-019, GC-020 frames only. Wide +16cm STD No Stabilizer
This wide swingarm for GC-019 and GC-020 aluminum frames is manufactured with the same width as the Monkey wide swingarm (width 187-190mm).
It can be used with the genuine Monkey hub, or with the 39048 wide rear disc hub.
This swingarm is compatible with both drum and disc brakes.
The triple square pipe swingarm, which adopts the strong "eye-shaped cross-section," is supported by over 80% of users who choose lengths of 16cm or more.
When installing 8-4.0J, a 4mm offset sprocket is required for the front and a 4mm sprocket spacer for the rear.
When installing 10-4.0, the offset can be done on the engine side, so a front sprocket is not required. (If using a normal hub, an 8mm offset sprocket spacer is required)
Compatible models
Monkey, Gorilla (for GC-019, GC-020 aluminum frames)
Surface treatment: Buffed finish
Size: +16cm
Material: 7N01, A5083 material used
Included accessories
(1) Chain adjuster block 1 set (specific to each pipe shape)
(2) Shock mounting bolt set
Bolt 1 (repair part number 65235)
Nut 1 (repair part number 65229)
Washer 2 (repair part number 65090/1 pc per pack)
(3) Seat fixing collar 22mm 2 (repair part number 68133/1 pc per pack)
(4) Drum brake rod 1 (depending on swingarm length)
(5) Axle shaft 230mm 1 (repair part number 38061)
(6) Axle collar 10mm 2 (repair part number 68134/1 pc per pack)
(7) Axle nut M12 1 (repair part number 38001)
Precautions
*STD (Standard), T/S (Triple Square), T/S Mini (Triple Square Mini), S/A (Swingarm) are abbreviations.
*Up to 8-inch 4.0J and 10-inch 4.0J can be installed. (+4cm or more is required)
*Only triple square pipes have chain sliders on the bottom as well.
*Please use genuine NSR50/80 rear shocks. (Ohlins TTX cannot be installed)
*The basic stabilizer is on the lower side.
*This product is exclusively for GC-019, GC-020 aluminum frames. Other frames are not compatible.
*When using a disc brake, the brake stopper needs to be cut. (Cut 10mm from the tip)
*The image is for illustration purposes only, and the design and specifications of the products listed may change without prior notice. Please be aware of this.