GC-019/GC-020 Frame-Specific Wide Swingarm Monoshock Standard with Stabilizer Buff +16cm Monkey Gorilla

[G-Craft 90620 Wide Swingarm for GC-019/GC-020 Frame Monoshock Standard with Stabilizer Buff +16cm Monkey Gorilla]
GC-019, GC-020 frame dedicated S/A Wide +16cm STD with Stabilizer
The wide swingarm for GC-019 and GC-020 aluminum frames is manufactured with the same width (187-190mm) as the Monkey wide swingarm.
You can use the genuine Monkey hub as is, or use the 39048 wide rear disc hub.
This swingarm is compatible with both drum and disc brakes.
The triple square pipe swingarm, which uses a strong "H-shaped cross-section," is supported by over 80% of users who choose lengths of 16cm or more.
When installing an 8-4.0J wheel, a 4mm offset sprocket is required for the front, and a 4mm sprocket spacer for the rear.
When installing a 10-4.0J wheel, the front sprocket is not required as it can be offset on the engine side. (If using a normal hub, an 8mm offset sprocket spacer is required)
Compatible models
Monkey, Gorilla (for GC-019, GC-020 aluminum frames)
Surface treatment: Buff finish
Size: +16cm
Material: 7N01, A5083 material used
Accessories
(1) Chain adjuster block 1 set (dedicated to each pipe shape)
(2) Shock mounting bolt set
Bolt 1 pc (Repair part number 65235)
Nut 1 pc (Repair part number 65229)
Washer 2 pcs (Repair part number 65090/1 pc)
(3) Seat fixing collar 22mm 2 pcs (Repair part number 68133/1 pc)
(4) Drum brake rod 1 pc (depending on swingarm length)
(5) Axle shaft 230mm 1 pc (Repair part number 38061)
(6) Axle collar 10mm 2 pcs (Repair part number 68134/1 pc)
(7) Axle nut M12 1 pc (Repair part number 38001)
Precautions
*STD (Standard), T/S (Triple Square), T/S Mini (Triple Square Mini), S/A (Swingarm) are abbreviations.
*Up to 8-inch 4.0J and 10-inch 4.0J can be installed. (+4cm or more is required)
*Only triple square pipes have chain sliders on the bottom.
*Please use genuine NSR50/80 rear shocks. (Ohlins TTX cannot be installed)
*The basic stabilizer is on the bottom.
*This is exclusively for GC-019 and GC-020 aluminum frames. Other frames cannot be installed.
*When using a disc brake, the brake stopper needs to be cut. (Cut 10mm from the tip)
*The image is for illustration purposes, and the design and specifications of the products shown may change without prior notice. Please understand.