GC-019/GC-020 Frame Only Wide Swingarm Monoshock Standard Stabilized Buff +20cm Monkey Gorilla

【G-Craft 90621 GC-019/GC-020 Frame Only Wide Swingarm Monoshock Standard with Stabilizer Buff +20cm Monkey Gorilla】
GC-019, GC-020 Frame Only S/A Wide +20cm STD with Stabilizer
The wide swingarm for GC-019 and GC-020 aluminum frames is manufactured with the same width as the Monkey wide swingarm (width 187-190mm).
You can use the stock Monkey hub as is, or use the 39048 wide rear disc hub.
This swingarm is compatible with both drum and disc brakes.
The triple-square pipe swingarm, which uses a strong "I-beam cross-section," is supported by over 80% of users who choose lengths of 16cm or more.
When installing 8-4.0J, a 4mm offset sprocket is required at the front, and a 4mm sprocket spacer is required at the rear.
When installing 10-4.0, the offset can be made on the engine side, so a front sprocket is not required. (If using a normal hub, an 8mm offset sprocket spacer is required)
Compatible models
Monkey, Gorilla (for GC-019, GC-020 aluminum frames)
Surface treatment: Buff finish
Size: +20cm
Material: 7N01, A5083 material used
Included accessories
(1) Chain adjuster 1 set (specific to each pipe shape)
(2) Shock mounting bolt set
Bolt 1 (Repair part number 65235)
Nut 1 (Repair part number 65229)
Washer 2 (Repair part number 65090/1 piece)
(3) Seat fixing collar 22mm 2 (Repair part number 68133/1 piece)
(4) Drum brake rod 1 (depending on swingarm length)
(5) Axle shaft 230mm 1 (Repair part number 38061)
(6) Axle collar 10mm 2 (Repair part number 68134/1 piece)
(7) Axle nut M12 1 (Repair part number 38001)
Precautions
*STD (Standard), T/S (Triple Square), T/S Mini (Triple Square Mini), S/A (Swingarm) are abbreviations.
*Up to 8 inch 4.0J and 10 inch 4.0J can be installed. (+4cm or more is required)
*Only triple square pipes have chain sliders on the bottom as well.
*Please use genuine NSR50/80 rear shocks. (Ohlins TTX cannot be installed)
*The basic stabilizer will be on the bottom.
*Only for GC-019, GC-020 aluminum frames. Other frames cannot be installed.
*When using a disc, the brake stopper needs to be cut. (Cut 10mm from the tip)
*The image is for illustration purposes only, and the design and specifications of the products shown are subject to change without notice. Please be aware.