GC-019/GC-020 Frame Only Wide Swingarm Monoshock Triple Square No Stabilizer Buffed +16cm Monkey Gorilla

【G-Craft 90624 GC-019/GC-020 Frame Only Wide Swingarm Monoshock Triple Square No Stabilizer Buff +16cm Monkey Gorilla】
S/A Wide +16cm T/S No Stabilizer for GC-019, GC-020 frames
The wide swingarm for GC-019 and GC-020 aluminum frames is a swingarm manufactured with the same width as the Monkey wide swingarm (width 187-190mm).
You can use the genuine Monkey hub as is, or use the 39048 wide rear disc hub.
This swingarm is compatible with both drum and disc brakes.
The triple square pipe swingarm, which uses a strong "I-beam cross-section," is supported by over 80% of users who choose 16cm or more.
When installing 8-4.0J, a 4mm offset sprocket is required for the front and a 4mm sprocket spacer for the rear.
When installing 10-4.0, the front sprocket is not required as it can be offset on the engine side. (If using a normal hub, an 8mm offset sprocket spacer is required)
Compatible models
Monkey, Gorilla (for GC-019, GC-020 aluminum frames)
Surface treatment: Buff finish
Size: +16cm
Material: 7N01, A5083 material used
Accessories
(1) Chain adjuster block 1 set (dedicated to each pipe shape)
(2) Shock mounting bolt set
Bolt 1 (Repair part number 65235)
Nut 1 (Repair part number 65229)
Washer 2 (Repair part number 65090/1 pc)
(3) Seat fixing collar 22mm 2 (Repair part number 68133/1 pc)
(4) Drum brake rod 1 (depending on swingarm length)
(5) Axle shaft 230mm 1 (Repair part number 38061)
(6) Axle collar 10mm 2 (Repair part number 68134/1 pc)
(7) Axle nut M12 1 (Repair part number 38001)
Notes
*STD (Standard), T/S (Triple Square), T/S Mini (Triple Square Mini), S/A (Swingarm) are abbreviations.
*Up to 8-inch 4.0J and 10-inch 4.0J can be installed. (+4cm or more is required)
*Only triple square pipes have chain sliders on the bottom.
*Please use genuine NSR50/80 for the rear shock. (Ohlins TTX cannot be installed)
*The stabilizer is basically on the bottom.
*For GC-019 and GC-020 aluminum frames only. Cannot be installed on other frames.
*When using disc brakes, the brake stopper needs to be cut. (Cut 10mm from the tip)
*Images are for illustration purposes only, and the design and specifications of the products shown may change without prior notice. Thank you for your understanding.