GC-019/GC-020 Frame Only, Wide Swingarm, Monoshock, Triple Square, No Stabilizer, Buff, +20cm, Monkey, Gorilla

【G-Craft 90625 GC-019/GC-020 Frame Only Wide Swingarm Monoshock Triple Square No Stabilizer Buff Finish +20cm Monkey Gorilla】
GC-019, GC-020 Frame Only S/A Wide +20cm T/S No Stabilizer
The wide swingarm for GC-019 and GC-020 aluminum frames is manufactured with the same width as the Monkey wide swingarm (width 187-190mm).
You can use the genuine Monkey hub as is, or use the 39048 wide rear disc hub.
This swingarm is compatible with both drum and disc brakes.
The triple square pipe swingarm, which adopts the strong "eyesore" cross-section, boasts over 80% support from users who choose 16cm or more.
When installing 8-4.0J, a 4mm offset sprocket is required for the front, and a 4mm sprocket spacer is required for the rear.
When installing 10-4.0, the front sprocket is not required as it can be offset on the engine side. (If using a normal hub, an 8mm offset sprocket spacer is required)
Compatible models
Monkey, Gorilla (for GC-019, GC-020 aluminum frames)
Surface treatment: Buff finish
Size: +20cm
Material: 7N01, A5083 material used
Accessories
(1) Chain adjuster block 1 set (dedicated to each pipe shape)
(2) Shock mounting bolt set
Bolt 1 (repair part number 65235)
Nut 1 (repair part number 65229)
Washer 2 (repair part number 65090/1 pc.)
(3) Seat fixing collar 22mm 2 (repair part number 68133/1 pc.)
(4) Drum brake rod 1 (depending on swingarm length)
(5) Axle shaft 230mm 1 (repair part number 38061)
(6) Axle collar 10mm 2 (repair part number 68134/1 pc.)
(7) Axle nut M12 1 (repair part number 38001)
Notes
*STD (Standard), T/S (Triple Square), T/S Mini (Triple Square Mini), S/A (Swingarm) are abbreviations.
*Up to 8-inch 4.0J and 10-inch 4.0J can be installed. (+4cm or more is required)
*Only triple square pipes have chain sliders on the bottom as well.
*Please use genuine NSR50/80 rear shocks. (Ohlins TTX cannot be installed)
*The basic stabilizer is on the lower side.
*Exclusive for GC-019 and GC-020 aluminum frames. Not compatible with other frames.
*When using a disc brake, the brake stopper needs to be cut. (Cut 10mm from the tip)
*Images are for illustration purposes only, and the design and specifications of the products shown may be changed without prior notice. Please note.