GC-019/GC-020 Frame Only Wide Swingarm Monoshock Triple Square with Stabilizer Buff +12cm Monkey Gorilla

【G-Craft 90626 GC-019/GC-020 Frame-Specific Wide Swingarm Monoshock Triple Square with Stabilizer Buff +12cm Monkey Gorilla】
GC-019, GC-020 frame-specific S/A Wide +12cm T/S with Stabilizer
The wide swingarms for GC-019 and GC-020 aluminum frames are manufactured with the same width (187-190mm) as the Monkey wide swingarm.
You can use the genuine Monkey hub as is, or use the 39048 wide rear disc hub.
This swingarm is compatible with both drum and disc brakes.
The triple square pipe swingarm, which employs a strong "closed-box section," is the pipe that boasts over 80% support among users who choose lengths of 16cm or more.
When installing an 8-4.0J setup, a 4mm offset sprocket is required for the front, and a 4mm sprocket spacer is required for the rear.
When installing a 10-4.0 setup, an offset can be achieved on the engine side, so a front sprocket is not required. (If using a normal hub, an 8mm offset sprocket spacer is required.)
Compatible models
Monkey, Gorilla (for GC-019, GC-020 aluminum frames)
Surface treatment: Buffed finish
Size: +12cm
Material: 7N01, A5083 material used
Accessories
(1) Chain adjuster set (specific to each pipe shape)
(2) Shock mounting bolt set
1 bolt (repair part number 65235)
1 nut (repair part number 65229)
2 washers (repair part number 65090/1 pc)
(3) 2 seat fixing collars 22mm (repair part number 68133/1 pc)
(4) 1 drum brake rod (according to swingarm length)
(5) 1 axle shaft 230mm (repair part number 38061)
(6) 2 axle collars 10mm (repair part number 68134/1 pc)
(7) 1 axle nut M12 (repair part number 38001)
Precautions
*STD (Standard), T/S (Triple Square), T/S Mini (Triple Square Mini), S/A (Swingarm) are abbreviations.
*Up to 8-inch 4.0J and 10-inch 4.0J can be installed. (+4cm or more is required.)
*Only triple square pipes have a chain slider on the bottom.
*Please use genuine NSR50/80 for the rear shock. (Ohlins TTX cannot be installed.)
*The basic stabilizer is on the bottom side.
*For GC-019 and GC-020 aluminum frames only. Other frames cannot be installed.
*When using a disc, it is necessary to cut the brake stopper. (Cut 10mm from the tip.)
*The image is for illustration purposes, and the design and specifications of the products shown may change without prior notice. Please understand.