GC-019/GC-020 Frame-Specific Wide Swingarm, Monoshock, Triple Square, with Stabilizer, Buff, +16cm, Monkey/Gorilla

【G-Craft 90628 GC-019/GC-020 Frame Only Wide Swingarm Monoshock Triple Square with Stabilizer Buff +16cm Monkey Gorilla】
For GC-019, GC-020 frames only. S/A Wide +16cm T/S with Stabilizer
This wide swingarm for GC-019 and GC-020 aluminum frames is manufactured with the same width (187-190mm wide) as the Monkey wide swingarm.
You can use the genuine Monkey hub as is, or use the 39048 wide rear disc hub.
This swingarm is compatible with both drum and disc brakes.
The triple square pipe swingarm, which uses a strong "I-beam cross-section," is supported by over 80% of users who choose 16cm or more.
When installing an 8-4.0J wheel, a 4mm offset sprocket is required for the front, and a 4mm sprocket spacer is required for the rear.
When installing a 10-4.0 wheel, the front sprocket is not required as it can be offset on the engine side. (If using a normal hub, an 8mm offset sprocket spacer is required)
Compatible models
Monkey, Gorilla (for GC-019, GC-020 aluminum frames)
Surface treatment: Buffed finish
Size: +16cm
Material: 7N01, A5083 material used
Accessories
(1) Chain adjuster block 1 set (specific to each pipe shape)
(2) Shock mounting bolt set
Bolt 1 pc (repair part no. 65235)
Nut 1 pc (repair part no. 65229)
Washer 2 pcs (repair part no. 65090 / 1 pc per pack)
(3) Seat fixing collar 22mm 2 pcs (repair part no. 68133 / 1 pc per pack)
(4) Drum brake rod 1 pc (depending on swingarm length)
(5) Axle shaft 230mm 1 pc (repair part no. 38061)
(6) Axle collar 10mm 2 pcs (repair part no. 68134 / 1 pc per pack)
(7) Axle nut M12 1 pc (repair part no. 38001)
Notes
*STD (Standard), T/S (Triple Square), T/S Mini (Triple Square Mini), S/A (Swingarm) are abbreviations.
*Up to 8-inch 4.0J and 10-inch 4.0J can be installed. (+4cm or more is required)
*Only triple square pipes have chain sliders on the bottom as well.
*Please use genuine NSR50/80 rear shocks. (Ohlins TTX cannot be installed)
*The basic stabilizer is on the bottom.
*For GC-019, GC-020 aluminum frames only. Cannot be installed on other frames.
*When using a disc brake, the brake stopper needs to be cut. (Cut 10mm from the tip)
*Images are for illustration purposes only, and the design and specifications of the products shown are subject to change without notice. Please be aware.