Super Wide Swing Arm Low Cost Twin Shock Standard With Stabilizer Buff +10cm Monkey Gorilla

【G-Craft 90663 Super Wide Swingarm Low Cost Twin Shock Standard with Stabilizer Buff +10cm Monkey Gorilla】
Monkey Super Wide S/A Low Cost STD Twin +10cm with Stabilizer
This is a swingarm for Monkey with the maximum width (207-210mm) that can accommodate 5.5J wide wheels. It is 20mm wider on each side compared to the genuine Monkey swingarm (width 167-170mm).
By installing the 39419 20mm sprocket spacer, you can use the genuine Monkey hub or a wide disc rear hub. This swingarm is compatible with both drum and disc brakes.
There are two types available: one that uses the 30047 Super Wide Shock Mount, and a low-cost type that does not use a shock mount.
■ If you want to change from drum specifications to disc specifications ■
The specifications can be changed by cutting the brake stopper.
Compatible models
Monkey, Gorilla
Surface treatment: Buffed finish
Size: +10cm
Material: 7N01, A5083 material used
Accessories
(1) Chain adjuster block 1 set (specific to each pipe shape)
(2) Twin shock mount bolts 1 set
(3) Drum brake rod 1 (depending on swingarm length)
(4) Axle shaft 250mm 1 (Repair part number 38053)
(5) Axle collar 20mm 1 (Repair part number 394216)
(6) Axle nut M12 1 (Repair part number 38001)
Precautions
*STD (Standard), T/S (Triple Square), T/S Mini (Triple Square Mini), S/A (Swingarm) are abbreviations.
*To prevent interference between the side stand and the stabilizer, the 30102 Stand Holder Type 2 is required for swingarms with stabilizers.
*Only the Triple Square pipe has chain sliders on the bottom as well.
*The shock mount on the low-cost type is approximately 30mm higher than that of the regular twin shock type.
*Depending on individual differences in the vehicle, the brake switch stay may interfere. In such cases, bend the brake switch stay and ensure the necessary clearance for operation before installation.
*Triple Square models come standard with a bearing-equipped pivot.
*When adding a stabilizer, installation of Stand Hook Type-2 (60903) is not possible.
*For +4cm, adding a stabilizer is not possible.
*The image is for illustration purposes only, and the design and specifications of the products shown are subject to change without notice. Please understand.