Super Wide Swingarm, Low-Cost Twin Shock, Triple Square with Stabilizer, Buffed, +4cm for Monkey Gorilla

【G-Craft 90666 Super Wide Swingarm Low Cost Twin Shock Triple Square with Stabilizer Buff +4cm Monkey Gorilla】
Monkey Super Wide S/A Low Cost T/S Twin +4cm with Stabilizer
This is the widest swingarm (207-210mm) for Monkeys that can accommodate 5.5J wide wheels. Compared to the genuine Monkey swingarm (167-170mm wide), it is 20mm wider on each side.
By installing the 39419 20mm sprocket spacer, you can use the genuine Monkey hub or a wide disc rear hub. This swingarm supports both drum and disc brakes.
There are two types available: one that uses the 30047 super wide suspension mount and a low-cost type that does not use the suspension mount.
■When you want to change from drum specifications to disc specifications■
You can change the specifications by cutting the brake stopper.
Compatible models
Monkey, Gorilla
Surface treatment: Buffed finish
Size: +4cm
Material: 7N01, A5083 material used
Accessories
(1) Chain adjuster block 1 set (dedicated for each pipe shape)
(2) Twin shock suspension mount bolt 1 set
(3) Drum brake rod 1 (according to the swingarm length)
(4) Axle shaft 250mm 1 (repair part number 38053)
(5) Axle collar 20mm 1 (repair part number 394216)
(6) Axle nut M12 1 (repair part number 38001)
Precautions
*STD (Standard), T/S (Triple Square), T/S Mini (Triple Square Mini), S/A (Swingarm) are abbreviations.
*To prevent interference between the side stand and the stabilizer, the 30102 stand holder type 2 is required for swingarms with stabilizers.
*Only Triple Square pipes have chain sliders on the bottom as well.
*The suspension mount on the low-cost type is about 30mm higher than that of the regular twin shock type.
*Due to individual differences in the vehicle, the brake switch stay may interfere. In such cases, bend the brake switch stay and ensure the necessary clearance for operation before installation.
*Triple Square is standard with a bearing specification at the pivot section.
*Stand hook Type-2 mounting processing (60903) is not possible when adding a stabilizer.
*Adding a stabilizer is not possible for +4cm.
*The image is for illustration purposes, and the design and specifications of the products shown are subject to change without notice. Please be aware.