Small All-LED Rear Combination Lamp Type A (Left) 24V

【KOITO KOITO LEDRCL-24LH Small All-LED Rear Combination Lamp Type A (Left) 24V Auxiliary Lamp for Trucks and Trailers】
Smart & Stylish
Revolutionary All-in-One
All functions condensed into a small unit
Long life achieved with Koito's LED technology
Hazard power-saving specifications available (92% reduction in power consumption compared to conventional models)
【UN ECE certified product】

Depending on the vehicle's model year and the combination of LED rear combination lamps, installation may not be possible.
Please check compatible vehicle models below.
Please note that this compatibility chart is reference information based on Koito Manufacturing's own research and does not guarantee compatibility.
Therefore, after installing the product on your vehicle, please perform an operation check and use it in a way that does not violate automotive laws and regulations, such as safety standards.
Specifications:
・Type: Type A (Left)
・Rating: 24V
・Tail: 0.4W
・Stop: 4.4W
・Turn: 24.0W
・Back: 3.7W
Compatible with:
・Toyota / Dyna, Hino / Dutro (representative examples)
Precautions:
*When purchasing, please check the mounting pitch of the light fixture currently installed.
*For hazard power-saving specifications, please use a left and right set, and be sure to use the optional hazard power-saving connection harness.
If not used, the hazard power-saving function will not operate correctly.
●This product is exclusively for 24V automobiles. Do not use it for vehicles other than 24V automobiles.
Furthermore, we are not responsible for any malfunctions that occur when used for purposes other than the specified applicable uses.
●Types A and B differ in hole diameter and connection connector, so please check before installation.
●The reverse buzzer emits sound from the bottom, so do not block the opening.
The sound may become inaudible.
●This LED rear combination lamp, repair parts (brackets), and optional parts are
intended for vehicles sold after 2010.
●Installation on trailers (towed vehicles) is not covered by the warranty.
●After installing this LED rear combination lamp, always check that the wire breakage detection function (built into the vehicle) as stipulated by safety standards operates correctly.
If the wire breakage detection function does not operate correctly, it will violate regulations and cannot be installed.
●In case of damage, replacement of the entire assembly is required.
●The inner surface of the lens may temporarily fog up due to rain or car washing.
This is the same phenomenon as window fogging during rain, etc., and there are no functional problems.
●If the outermost edge of the reflex reflector built into the rear combination lamp extends beyond 400mm (Koito recommends 385mm) from the outermost edge of the vehicle,
install the included reflex reflector within 400mm from the outermost edge of the vehicle / the upper edge of the reflex reflector within 900mm from the ground, and the lower edge at least 250mm from the ground.
●To use and install this product in the best possible condition, please be sure to read the "Instruction Manual" and "Precautions for Use" included with the product carefully and use it correctly after understanding the contents.
●This product is exclusively for automobiles. Do not use it for vehicles other than automobiles.
Furthermore, we are not responsible for any malfunctions that occur when used for purposes other than the specified applicable uses.
●Please use it in a way that does not violate automotive laws and regulations, such as safety standards.
●Specifications and production are subject to change or discontinuation without prior notice. Please be aware of this.
*The actual specifications may differ for the left and right sides.
*The image is for illustration purposes only, and the design and specifications of the products shown may change without notice. Please understand.