Handlebar 30mm Back Matte Black Rebel 1100DCT/T/S Edition

【Kijima 204-3399 Handlebar 30mm Back Matte Black Rebel 1100DCT/T/S Edition Handlebar Bike Parts KIJIMA】
■Product Description
This dedicated handlebar moves the grip position 20mm closer to the rider and 30mm higher, achieving a more comfortable riding position (individual results may vary).
No need to replace cables or wires, and since the change in vehicle dimensions falls within the safety standards, no application procedures are required.
Bolt-on design that meets safety standards and does not require structural modification.
The original holder's rotation stopper hole and positioning punch mark are already marked.
An M10 P1.25 screw is inserted inside the handlebar end, allowing the use of the original bar end.

■Compatible Models
HONDA
Rebel 1100DCT/T/S Edition (8BL-SC87) 2025-
*Can also be installed on MT models. However, a clutch cable set (202-9995) is required.

■Specifications
Color: Matte Black
W (Overall Width): 745mm
H (Height): 105mm
R (Pullback): 230mm
L (Clamp Width): 160mm
Clamp section: 1 inch (25.4mm)
Grip section: 7/8 inch (22.2mm)
Material: Steel

■Notes
*Images are for illustration purposes only. Includes products with different sizes and colors.
*Product design and specifications are subject to change without notice. Thank you for your understanding.
*The genuine grip heater (left side) may be damaged during removal. If damaged, new replacement is required.
*Similar to the genuine part, the distance from the center to the end is asymmetrical on the left and right. Please be aware of this in advance.
*It is not necessary to change cables, hoses, or harnesses, but if you are concerned about their routing, please replace them with appropriate lengths. After installation, adjustment of the parking brake tension, etc., is required.
*Depending on the thickness of the paint, throttle rotation may become heavy. In such cases, shave the handlebar side to adjust.
*The positioning punch marks are for reference. Check for tank interference, etc., and make final adjustments to your preferred position.
*There may be a slight misalignment in the holes for fixing the switch box. In such cases, processing such as enlarging the holes is required.