Super Power Filter All-Weather φ35 Straight Plated

[KITACO 515-0500353 Super Power Filter All-Weather φ35 Straight Plated KITACO 515-0500353]
This air filter is recommended for use with standard carburetors.
Intake efficiency will change, so carburetor adjustment is necessary.
When riding in the rain, water may enter the filter, causing carburetor settings to change.
For emission-regulated models from 2000 onwards: Since emission-regulated models use lean combustion, it may not be possible to achieve proper settings, so installing power filters or similar items is not recommended.
For F1 vehicles: Do not install power filters, air funnels, etc., directly on F1 vehicles, as this will disrupt fuel regulation.
However, this excludes cases where a device for fuel regulation (injection controller, KITACO I-MAP) is installed and settings can be adjusted.
If the filter diameter is a few millimeters smaller than the carburetor opening of the vehicle, it will be a bit tight when fitting, but it can be installed by pushing it in.
When a long rear shock is installed, the filter may interfere with the body.
This type is less affected by conditions.
With a hood, it effectively protects against dirt and dust, as well as rain.
It improves intake efficiency and increases power.
Pay attention to the mounting angle. If the cover is installed upside down, water may accumulate inside the cover during rainfall, potentially obstructing intake.
The dimensions indicate the length from the top of the filter to the bottom of the rubber pipe when the filter is standing vertically.
Carburetor adjustment is required after installation.
Size: Diameter φ35 x Height 68 x Width 70mm
Carburetor adjustment is required for installation.
*The image is for illustration purposes only, and the design and specifications of the products shown may be changed without prior notice. Please be aware of this.