Drive Sprocket Rear 40T 420 Size RZ50 TZM50R

[KITACO 535-0019240 Drive Sprocket Rear 40T 420 Size RZ50 TZM50R KITACO 535-0019240]
There is no clear standard for when to replace a sprocket, making it very ambiguous.
One way to judge is by "tooth wear."
If the teeth become pointed, or the belly or sides are worn down, it's time for a replacement.
Simultaneous replacement of front and rear sprockets and chain If you only replace one part, the worn unreplaced parts will prevent the new parts from performing at their original capacity and durability, causing them to wear out sooner. Therefore, in the long run, it is recommended to replace all three parts simultaneously for better longevity.
This is the rear sprocket (wheel side).
To allow for fine-tuning, it supports tuners with a wide range of teeth and reasonable pricing.
Made of highly durable chromoly high-tensile steel.
Sprockets are consumables.
As a general guideline, inspect the sprocket approximately every 1000km of normal riding (the lifespan of the sprocket and chain can be significantly extended by daily lubrication).
The larger the reduction ratio (rear sprocket tooth count ÷ front sprocket tooth count), the more emphasis is placed on acceleration; the smaller the value, the more emphasis is placed on top speed.
Compatible models: RZ50 5R6/1HK
RX50 (cast wheels) all models
TZM50R all models
YB-1 58E all models
YB-1 (FOUR) 5JE all models
YB50 58E
TT-R50E all models
*The image is for illustration purposes only, and the design and specifications of the products shown may change without prior notice. Please understand.