Drive Sprocket Rear 41T 420 Size RZ50 TZM50R

[Kitaco 535-0019241 Drive Sprocket Rear 41T 420 Size RZ50 TZM50R Kitaco 535-0019241]
There is no clear standard for when to replace a sprocket, making the timing very ambiguous.
One criterion for judgment is "tooth wear."
If the teeth become pointed or the belly or sides are worn down, it's time for a replacement.
Simultaneous replacement of front and rear sprockets and chain If you only replace one of the three, the new parts will not be able to perform as intended or last as long due to the unreplaced worn parts, leading to an earlier replacement time. Therefore, considering the long term, simultaneous replacement of all three is recommended as it will last longer.
This is the rear (wheel side) sprocket.
To enable fine-tuning, it supports tuners with a wide range of teeth counts and reasonable pricing.
It uses high-tensile chromoly steel, boasting high durability.
Sprockets are consumable parts.
As a general guideline for normal driving, inspect the sprocket every approximately 1000km (regular lubrication significantly improves the lifespan of sprockets and chains).
The larger the reduction ratio (rear sprocket teeth count ÷ front sprocket teeth count), the more acceleration-oriented the setup; the smaller the ratio, the more top-speed-oriented it is.
Compatible models: RZ50 5R6/1HK
RX50 (cast wheels) all models
TZM50R all models
YB-1 58E all models
YB-1 (FOUR) 5JE all models
YB50 58E
TT-R50E all models
*The image is for illustration purposes only, and the design and specifications of the products shown may change without prior notice. Please be aware of this.