Drive Sprocket, Rear, 48T, 428 size, TZR50 TZ50

[KITACO 535-0077248 Drive Sprocket Rear 48T 428 Size TZR50 TZ50 KITACO 535-0077248]
There is no clear or precise standard for when to replace a sprocket.
However, a key indicator is "tooth wear."
It's time for replacement when the tooth tips become sharp, or the belly or sides are worn down.
Simultaneous replacement of front and rear sprockets and chain If you only replace one of these three components, the worn parts that haven't been replaced will prevent the new parts from performing at their best and shorten their lifespan. Therefore, replacing all three simultaneously is recommended for long-term durability.
This is the rear (wheel side) sprocket.
To enable precise tuning, we support tuners with a wide range of tooth counts and reasonable pricing.
Made from high-strength chromoly steel for excellent durability.
Sprockets are consumables.
As a general guideline for normal driving, please inspect the sprocket approximately every 1000km (regular lubrication significantly improves the lifespan of both sprockets and chains).
Rear sprocket tooth count ÷ Front sprocket tooth count = Reduction ratio. A higher number indicates a focus on acceleration, while a lower number indicates a focus on top speed.
Compatible models: TZR50R (all models)
TZR50 (all models)
TZ50 (all models)
*Images are for illustration purposes only. The design and specifications of the products shown are subject to change without notice. Please be aware of this.