Drive Sprocket, Rear, 31T, 420-size, DAX, APE50-100

[KITACO 535-1015231 Drive Sprocket Rear 31T 420 Size DAX APE50-100 KITACO 535-1015231]
There is no clear standard for when to replace a sprocket, making it very ambiguous.
The determining factor in such cases is "tooth wear."
It's time to replace the sprocket when the teeth become pointed, or the belly or sides of the teeth wear down.
Simultaneous replacement of the front sprocket, rear sprocket, and chain: If you only replace one of these three parts, the worn parts that were not replaced will prevent the new part from performing at its full potential and durability, leading to premature replacement. Therefore, considering the long-term, it is recommended to replace all three simultaneously for better longevity.
This is the rear sprocket (wheel side).
To enable fine-tuned settings, we support tuners with a wide range of tooth counts and reasonable pricing.
Made from highly durable chromoly high-tensile steel.
Sprockets are a consumable part.
As a guideline for general riding, please inspect your sprocket every approximately 1000km (regular lubrication significantly extends the life of both the sprocket and chain).
Rear sprocket teeth count ÷ Front sprocket teeth count = Gear ratio. A higher gear ratio indicates a focus on acceleration, while a lower ratio indicates a focus on top speed.
Compatible models: APE50/100, Giorno Cub, DAX
Monkey RT, Magna 50, JAZZ, etc.
*Images are for illustration purposes only, and the design and specifications of the products shown may change without prior notice. Please be aware of this.