Drive Sprocket Rear 34T 420 Size DAX APE50-100

[KITACO 535-1015234 Drive Sprocket Rear 34T 420 size DAX APE50-100 KITACO 535-1015234]
Replacing sprockets There is no clear standard for when to replace sprockets, making it very ambiguous.
One indicator is "tooth wear."
When the teeth become pointed, or the belly or sides are worn down, it's time for a replacement.
Simultaneous replacement of front and rear sprockets and chain If you only replace one part, the worn parts that haven't been replaced will prevent the new parts from performing at their original capacity and durability, causing them to wear out prematurely. Therefore, considering the long term, replacing all three at once is recommended for longer life.
This is the rear (wheel side) sprocket.
To enable fine-tuned settings, we support tuners with a wide range of tooth counts and reasonable pricing.
Made from highly durable chromoly high-tensile steel.
Sprockets are consumables.
As a general guideline for normal driving, inspect the sprocket approximately every 1000km (regular lubrication significantly improves the lifespan of both sprockets and chain).
Rear sprocket tooth count ÷ Front sprocket tooth count = Reduction ratio. A higher value indicates a focus on acceleration, while a lower value indicates a focus on top speed.
Compatible models: APE50/100 Giorno Cub Dax
Monkey RT Magna 50 JAZZ, etc.
*Images are for illustration purposes only, and the design and specifications of the products shown may change without notice. Please be aware.