Drive Sprocket Rear 38T 420 Size DAX APE50-100

[Kitaco 535-1015238 Drive Sprocket, Rear, 38T, 420 size, DAX APE50-100 Kitaco 535-1015238]
When to replace a sprocket is very ambiguous, as there is no clear standard.
One factor in determining this is "wear on the teeth tips."
It is time to replace the sprocket when the tooth tips become pointed or the belly and sides are worn down.
Simultaneous replacement of front and rear sprockets and chain (all three parts) If you only replace one of these parts, the worn parts that were not replaced will prevent the new parts from performing at their original level or achieving their full durability, thereby shortening their lifespan. Therefore, considering the long run, it is recommended to replace all three parts simultaneously for greater longevity.
This is the rear sprocket (wheel side).
To enable fine-tuned settings, we support tuners with a wide range of tooth counts and reasonable pricing.
Made from high-durability chromium molybdenum high-tensile steel.
Sprockets are consumables.
For general riding, inspect the sprocket approximately every 1000km (regular lubrication significantly improves the lifespan of the sprocket and chain).
The larger the reduction ratio (rear sprocket teeth ÷ front sprocket teeth), the more acceleration-oriented it is; the smaller the ratio, the more top-speed-oriented it is.
Compatible models: APE50/100, Giorno Cub, Dax
Monkey RT, Magna 50, JAZZ, etc.
*The image is for illustrative purposes only, and the design and specifications of the products shown may change without prior notice. Please be aware of this.