Drive Sprocket, Rear, 38T, 420 Size, Super Cub 50, CD50

[KITACO 535-1086238 Drive Sprocket Rear 38T 420 Size Super Cub 50 CD50 KITACO 535-1086238]
The timing for replacing sprockets is very ambiguous, with no clear standards.
One factor that can help in deciding is "tooth wear."
If the teeth become pointed, or if the belly or sides are worn down, it's time for a replacement.
Simultaneous replacement of front and rear sprockets and chain If only one part is replaced, the worn parts that haven't been replaced will prevent the new parts from performing at their best and lasting as long as they should, leading to an earlier replacement time. Therefore, considering the long-term, it is recommended to replace all three parts simultaneously for better durability.
This is the sprocket on the rear side (wheel side).
To enable fine-tuned settings, we support tuners with a wide range of tooth counts and reasonable pricing.
Made from high-tensile chromoly steel, boasting high durability.
Sprockets are consumable parts.
As a general guideline for normal driving, inspect the sprocket approximately every 1000km (regular lubrication significantly improves the lifespan of sprockets and chains).
The larger the reduction ratio (rear sprocket teeth ÷ front sprocket teeth), the more acceleration-oriented the setup; the smaller the ratio, the more top speed-oriented.
Compatible models: Super Cub 50 (C50-6000037-/9600001-0095210/0200001-/AA01-1000001-1699999) ・FI models (AA01-1700001-) *Cannot be used with press cub ・Little Cub (C500-4300001-AA01-1000001-3999999) ・Little Cub 50 (FI model AA01-4000001-) ・Super Cub 70 (C70-7000036-) ・Super Cub 90 (C90-3000006-/HA02-1100017-) ・CD50/Benly 50S/CL50 (CD50-1300001-) ・CD90/Benly 90S (HA03-1000003-)
*The image is for illustration purposes only, and the design and specifications of the products displayed may change without prior notice. Thank you for your understanding.