Driven Sprocket Rear 35T 420 Size KSR110

[Kitaco 535-4021235 Driven Sprocket Rear 35T 420 Size KSR110 Kitaco 535-4021235]
The replacement timing for sprockets is very ambiguous, with no clear standards.
"Wear on the tooth tips" is the key indicator for this decision.
It is time to replace the sprocket when the tooth tips become pointed, or the belly or sides show wear.
Simultaneous replacement of front and rear sprockets and chain If you replace only one of these three parts, the worn, unreplaced parts will prevent the newly replaced parts from performing to their full potential and durability, leading to an earlier replacement time. Therefore, considering the long run, simultaneously replacing all three parts is recommended for longer life.
This is the rear (wheel side) sprocket.
We support tuners with a wide range of tooth counts and reasonable prices to enable fine-tuned settings.
Made from highly durable chrome molybdenum high-tensile steel.
Sprockets are consumables.
As a general guideline, inspect your sprocket every approximately 1000km of travel (regular lubrication significantly improves the lifespan of both the sprocket and chain).
The larger the deceleration ratio (rear sprocket tooth count ÷ front sprocket tooth count), the more acceleration-oriented the setup; the smaller the ratio, the more top speed-oriented.
Compatible models: KSR110 KL110A (all models)
KLX110 LX110A (all models)
*Images are for illustration purposes only. The design and specifications of the products shown may change without prior notice. Please be aware of this.