Brake pads Sintered ceramic

【ZCOO ZRM-B001 Brake Pads Ceramic Sintered Motorcycle Parts Custom Parts Brake Related Parts】
■Product Description
Ceramic sintered brake pads that provide braking power proportional to how hard you squeeze the lever.
These pads were developed and set to provide braking power that increases smoothly as you squeeze, rather than an abrupt, sudden stop, like "squeezing a silk floss."
Furthermore, we pursued a "comfortable decelerating sensation" where the rider experiences more deceleration than they perceive, allowing for smooth, controlled braking.
Since it has little temperature dependency (※1), which is common with racing brake pads, it can be used safely on public roads.
(※1) Refers to the phenomenon where braking power is not achieved until a certain temperature range is reached.

■Specifications
Size: 51.15 x 69.7

■Other Notes
・Brake pads are critical safety components, so replacement and installation are recommended to be performed by a certified workshop and qualified personnel. When performing replacement and installation under your own responsibility, it is mandatory to record the maintenance details in the maintenance logbook and keep it with the vehicle. Please note that we are not responsible for any accidents caused by defects resulting from the replacement.
・Brake-related parts immediately after driving are hot. Please ensure that the pads and rotors are completely cool before performing replacement work.
・Pads contain fibers, which may prick your hands. Always wear work gloves when performing replacement work.
・Brake pads are consumables. If the friction material wears down to 2mm, be sure to replace them.
・Before replacing brake pads, always confirm that the brake pads and vehicle are compatible. Do not install or use them on incompatible vehicles, or modify or process the product.
・When replacing pads, be careful not to get oil, dust, or other contaminants or foreign matter on the surface.
・For vehicles with double disc specifications, always replace the brake pads on both sides simultaneously.
・When installing (replacing) brake pads, refer to the service manual and check for scratches, ruptures, deformation, or abnormal friction material on the rotor, brake hose, etc.
・After replacing brake pads, perform sufficient break-in until the sliding surfaces are evenly in contact. Immediately after replacement, the pad and rotor wear surfaces are not in full contact, so the original braking force cannot be obtained.
・When replacing, simultaneously inspect the brake fluid (oil), calipers, rotors, etc. The performance of brake pads is greatly affected by the quality of caliper maintenance, so if there are any deficiencies or problems, take appropriate action immediately.
・Using pads that have exceeded their wear limit can damage the rotor and lead to accidents, so regularly check the remaining pad material and for other damage. If any abnormality is found, it is very dangerous, so discontinue use.
・Be very careful not to subject the brake pads to impacts such as dropping. This can cause damage to the product, preventing it from achieving its original braking performance, and in some situations, leading to accidents. Handle with extreme care.
・Do not use sintered grip pads on cast iron discs (rotors).

■Notes
※Images are for illustration purposes. Includes products with different sizes and colors.
※Product design and specifications are subject to change without notice. Thank you for your understanding.